Weltrode WC 8100H AC-DC
Sizes :
2.5 x 300 mm
3.15 x 350 mm
4 x 350 mm
Availability : In Stock
Premium Electrode For Cast Iron Draw Dies And Maintenance Welding (Iron Base).
- Used For Build Up Of Wearing Surfaces On All Types Of Iron Draw Dies Including Gray, Nodular, Ductile And Special Cast Alloys.
- Can Be Used For Joining Steel To Cast Iron Where High Strength Is Required.
- Specially Alloyed Coating Materials And Fluxing Agents Produce Porus Free Welds.
- The Flux Coating Of Weltrode Wc 8100H Does Not Contain “ Barium” Thus Eliminating Hazardous Fumes During Welding.
- Deposits Are Long Wearing And Develop A High Polish While In Service.
- All Position Welding Possible.
- To Be Used Where High Hardness Is Required In Draw Dies Such As Draw Beads Hold Down Beads, High Light Lines And Draw Radii Areas On Female Dies.
- Used For Cracked High Alloy Tool Steel Dies Made From D-2, D-6, D-7 And Other High Carbon Alloy Steels.
TensileStrength 68,000 PSI
Hardness RC34-36 As Welded
RC40-42 Work Hardened
YieldStrength 47,000 PSI
Elongation 20%
- Remove All Rust, Scale And Scale From The Surface To Be Welded.
- Adjust Amperage Within Recommended Range And Deposit Electrode, Maintaining A Short To Medium Arc Length.
- Tilt The Electrode 30 Degrees In The Direction Of Travel.
- Use Stringer Bead Or Moderate Weave Technique And Back-Whip All Craters.
- Use Reverse Polarity On DC.